EPSON Stylus Photo R200/R210 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 59
n Make sure that "Waste Ink Pads" (x6) are set correctly to
the rib and the dowel of "Housing, Lower".
Figure 2-33. "Waste Ink Pads" installation (1)
Cap, Ink Pad, Lower,
Large (Bottom)
Waste Ink Pad, Upper (Top)
Waste Ink Pad, Lower (Bottom)
Cap, Ink Pad, Lower,
Small (Top)
Waste Ink Pad, Small
Figure 2-34. "Waste Ink Pads" installation (2)
n After checking "Waste Ink Tube" is under "Waste Ink Pad,
Lower", put the jig on the indicated points in the figure
below, then install "Porous Pad, Ink Eject, Upper, Support".
Figure 2-35. "Porous Pad, Ink Eject, Upper, Support" installation
Jig
Porous Pad, Ink Eject,
Upper, Support
Waste Ink Pad, Lower
Adjusting Point
To Next Page
Loading...
