Epson RC180 Safety And Installation

2. Installation
RC180 Safety and Installation Rev.18
52
RS
■
Install the Manipulator with two or more people.
The Manipulator weights are as follows. Be careful not to get
hands, fingers, or feet caught and/or have equipment damaged by
a fall of the Manipulator.
RS3-351*: approx. 17 kg : 38 Ib. (except cables)
RS4-551*: approx. 19 kg : 42 Ib. (except cables)
CAUTION
■
When installing the Manipulator to the ceiling, support the
Manipulator, and then secure the anchor bolts. Removing the
support without securing the anchor bolts properly is extremely
hazardous and may result in fall of the Manipulator.
(1)
Unpack the Manipulator with
retaining the arm posture.
(2) Secure the base to the wall with 6
bolts.
Intensity of the bolts should be
equivalent to ISO898-1 Property
Class 10.9 or 12.9.
(3) Remove the shipping bolt and jigs.
6-M6
×
20
Screw hole
(Depth: 12 mm
or more)
)
NOTE

Epson RC180 Specifications

General

Brand	Epson
Model	RC180
Category	Controller
Language	English