Epson SC-F2100 SERIES User Manual

C
Gently hold the section that was peeled off the
pad, and then stick the grip pad.
D
Peel off all of the other sections on the back of the
grip pad as shown in the illustration.
E
Stick it from the end that is already stuck, as
shown in the illustration.
F
Peel off all of the sections around the edges on the
back of the grip pad as shown in the illustration.
G
Fold over the long edges of the grip pad and stick
them to the back of the platen without allowing
the pad to loosen or sag.
H
Fold over and stick all of the corners of the grip
pad.
I
Fold over and stick the short edges.
J
Turn the platen over and press down the folded
edges of the grip pad to stick them firmly in place.
Removing the Sheet
c
Important:
❏ Do not apply hot air such as a drier to soften the
glue. Failure to observe this precaution could
result in deformed parts.
❏ Do not use organic solvents such as alcohol.
Failure to observe this precaution could result
in discoloration, warping, or damage to parts.
SC-F2100 Series User's Guide
Basic Printing
38

Epson SC-F2100 SERIES Specifications

General

Ink Type	Epson UltraChrome DG ink
Maximum Print Resolution	1440 x 1440 dpi
Connectivity	USB, Ethernet
Printable Area	Up to 16" x 20"
Ink Colors	Cyan, Magenta, Yellow, Black, White
Printer Type	Direct-to-Garment Printer
Operating System Compatibility	Windows, Mac
Platen Sizes	Small, Medium, Large
Print Speed	Up to 27 seconds for a light garment