Epson SC-F9200 series User Manual

G
On the rear of the printer, loosen the roll holder
fixing screws on the left and right sides. Next,
tighten the roll holder fixing screw to align the
left roll holder with the position of dotted line.
H
Adjust the right roll holder so that the distance
between the two is wider than the roll core.
c
Important:
If the right holder handle shaft is not visible,
rotate the handle as shown in the illustration
below until it stops.
I
Pass film a through the roll core.
J
Insert the roll core into the left roll holder. Next,
insert the right roll holder into the roll core, and
then tighten the roll holder fixing screw.
SC-F9200 Series User's Guide
Appendix
120

Epson SC-F9200 series Specifications

General

Brand	Epson
Model	SC-F9200 series
Category	Printer
Language	English