Caution:
❏ The printer is heavy. When you pack or move
the printer, use four or more people when
carrying it.
❏ When you lift the printer, maintain a natural
posture.
❏ When you lift the printer, place your hands at
the locations indicated in the following
illustration.
If you lift the printer while holding other
sections, you may be injured. For example, you
may drop the printer or your fingers may be
pinched when lowering the printer.
When you move the printer while packaging it, place
your hands at the positions in the illustration, and then
lift.
c
Important:
❏ Only hold the required area; otherwise, the
printer may be damaged. Failure to observe this
precaution could damage the printer.
❏ Move and transport the printer with ink
cartridges installed. Do not remove the ink
cartridges; otherwise, the nozzles may be
clogged and make it impossible to print, or ink
may leak.
Notes when reusing the printer
After moving or transporting the printer, follow the
steps below to put it into a ready status.
See the Choosing a Place for the Printer section of the
"Setup Guide" (booklet) in advance to make sure the
location is suitable for installing the printer.
A
See the "Setup Guide" to install the printer.
U "Setup Guide" (booklet)
c
Important:
Make sure you lock the casters after installing
the printer.
B
Print a check pattern and check for clogged
nozzles.
U “From the printer” on page 126
C
Perform Head Alignment (auto adjustment).
U “From the printer” on page 126
SC-P9000 Series/SC-P7000 Series/SC-P8000 Series/SC-P6000 Series User's Guide
Appendix
181
To Next Page
Loading...
