Paper menu
If you use the Custom Paper Setting to register print settings for commercial paper on the SC-T7200D Series/
SC-T5200D Series, observe the following precautions.
If you are printing on both the Roll 1 and Roll 2, configure them individually, even when the paper is the same. If the
Custom Paper Setting set by the conditions set in Roll 1 is applied to the same type of paper loaded in Roll 2, but the
paper path, paper width, or other print conditions are different, printing will not be performed correctly.
*1. SC-T7200D Series/SC-T5200D Series only
*2. SC-T7200 Series/SC-T5200 Series/SC-T3200 Series only
*3. When the optional hard disk unit or Adobe PostScript 3 Expansion Unit has been connected only
*4. When the optional Adobe PostScript 3 Expansion Unit has been connected only
* Default setting
Item Description
Load/Remove Paper Remove Paper Instructions are not displayed if no paper is loaded.
Roll Paper
*2
Highlight the paper to be loaded and press the Z
button. Follow the on-screen instructions to load
the paper.
If paper is already loaded in the printer, the
instructions for removing the loaded paper type
will be displayed before loading instructions are
shown.
Roll 1
*1
Roll 2
*1
Cut Sheet (up to 0.8
mm thick)
Poster Board
Select
Paper Type
Plain Paper Select the type of paper loaded.
Photo Paper
Matte Paper
Others
Custom Paper Select the name of the custom paper loaded in the printer.
SC-T7200 Series/SC-T5200 Series/SC-T3200 Series/SC-T7200D Series/SC-T5200D Series User's Guide
Using the Control Panel Menu
141
To Next Page
Loading...
Need help?
General
