Epson SC-T5200 Series User Manual

Note:
The CAD / Line Drawing (Black), CAD / Line
Drawing (Color) , and CAD / Line Drawing
(Bi-Level) options are available for Select Target
when a paper type suited to printing CAD drawings
is selected.
B
Check other settings, and then start printing.
Mac OS X
A
Display the print dialog and select Printer
Settings from the list.
U “Basic Printing Methods(Mac OS X)” on
page 60
B
Set Mode to Select Target, and then select CAD /
Line Drawing (Black), CAD / Line Drawing
(Color), or CAD / Line Drawing (Bi-Level).
Note:
The CAD / Line Drawing (Black) and CAD / Line
Drawing (Color) options are available for Select
Target when a paper type suited to printing CAD
drawings is selected.
C
Check other settings, and then start printing.
Printing while Emulating HP-GL/
2 and HP RTL
The printer can emulate
*
HP-GL/2 (compatible with
HP Designjet 750C) and HP RTL.
When you want to print with applications using
HP-GL/2 or HP RTL output, configure the output
equipment as shown below according to your model.
❏ SC-T7200 Series/SC-T7200D Series/SC-T5200
Series/SC-T5200D Series
HP Designjet 750C C3195A
❏ SC-T3200 Series
HP Designjet 750C C3196A
* Not all functions are supported. If you will use an
untested application, test its output in advance.
For a list of applications that have been tested, visit
the Epson website at http://www.epson.com.
c
Important:
The printer may not perform as expected if the
volume of the data to be printed is extremely large.
When you will print while emulating HP-GL/2 and HP
RTL, observe the following points.
❏ Select Paper Type setting
Set one of the following options for the Select Paper
Type setting of the printer. If other paper types are
used, print quality may be reduced.
Singleweight Matte/Plain Paper/Tracing Paper/
Tracing Paper <Low Duty>
❏ HP-GL/2 Settings
When you will print while emulating HP-GL/2 and
HP RTL, set the Print Settings as follows: On the
printer, select Setup menu > Printer Setup >
HP-GL/2 Settings.
U “Setup menu” on page 146
SC-T7200 Series/SC-T5200 Series/SC-T3200 Series/SC-T7200D Series/SC-T5200D Series User's Guide
More Ways to Print
90

Epson SC-T5200 Series Specifications

General

Memory	1 GB
Print Resolution	2880 x 1440 dpi
Print Speed	28 seconds per A1 sheet
Paper Sizes	A0, A1, A2, A3+, A3, A4
Print Margin Roll	3 mm (top, side, bottom)
Interfaces	USB 2.0, Ethernet
Hard Disk	320 GB
Acoustic Noise	50 dB(A)
Dimensions	1405‎ x 813 x 1128 mm (Width x Depth x Height)
Ink Colors	Cyan, Magenta, Yellow, Black
Media Types	Plain paper, Photo paper
Operating Systems	Mac OS X 10.6.8 or later