Removing the Spindle Unit
c
Important:
When the
light is lit and paper is ejected from the eject slot, there is no remaining paper. Pull out the paper from the
eject slot.
A
Check that the printer's light is on.
If the
light is flashing, the printer is operating. Wait until all operations have stopped.
c
Important:
Make sure the power is on before replacing paper.
B
To rewind the paper to the replacement position, remove the Scrap paper box, and then reattach it.
Wait until the printer's
light stops flashing and remains on.
Removing: Pull the top section forward and then lift out the bottom section.
Attaching: Insert the bottom section, and then push the top section into place.
SL-D700 Operation Guide
Replacing Paper
27
To Next Page
Loading...
