Code Message What to do
W-5105 Paused
You cannot print when it is in pause.
Click [Resume] to print when displayed, or click [Print Queue]
and deselect "Pause Printing" in the "Printer" menu.
If Resume is displayed in the printer
window, click it to resume printing. If it
is not displayed, click Print Queue, and
then resume printing manually.
E-2101 to E-2104 Parts have reached the end of their service life.
xxxxxx
Contact a technical representative.
Delete all print jobs remaining in the operating system's print
queue.
After deleting all of the print jobs,
contact service support and request
replacement for the part displayed in
xxxxxx.
E-9901 A printer system error occurred.
Delete all print jobs remaining in the operating system's print
queue.
Turn the printer off. Check if there is any paper remaining inside
the printer, and then turn the printer back on.
Contact service support if the error continues to occur.
After deleting all of the print jobs,
restart the printer.
If the error persists, a malfunction may
have occurred. Contact service
support.
I-5201 Amount of data in print jobs sent to printer nearly at maximum
limit.
Stop sending the current print job and send the remaining
pages as another print job.
The print job is too large.
After deleting all of the print jobs, split
up the data, and then try printing
again.
W-5202 Amount of data in print jobs sent to printer is at maximum limit.
Stop sending the current print job and send the remaining
pages as another print job.
The print job is too large.
After deleting all of the print jobs, split
up the data, and then try printing
again.
I-5202 The Maintenance function is running.
Wait until maintenance is complete.
Wait for a while.
I-5203 The paper set in Print Settings and the paper loaded in the
printer differ.
Change the paper, and then click [OK]. To continue printing with
the current settings, click [Print].
Load the appropriate paper. After
replacing the paper, set the Paper Type
and the Paper Level in the
Maintenance Tool.
U “Replacing Paper” on page 23
To continue printing with the current
settings, click Print.
W-2206 You have not installed genuine Epson ink cartridges.
xxxx
Information about ink levels may not be displayed, and use of
non-genuine ink is recorded for possible use in service support.
For optimum quality and reliability Epson recommends using
genuine Epson ink.
This printer is developed for use with
genuine ink cartridges. If you use
non-genuine cartridges, the print
result may be faint, or the ink
remaining may not be detected
normally. We recommend using
genuine Epson products.
W-2207 A non-genuine or refilled cartridge has been detected. Ink levels
may not be shown because of unknown ink volume.
W-2208 A non-genuine or refilled cartridge has been detected. Ink levels
may not be shown because of unknown ink volume.
SL-D700 Operation Guide
Troubleshooting
73
To Next Page
Loading...
