Epson SL-D700 - Page 96

Basic specifications
Nozzle configuration 180 nozzles for each color
Print direction Bidirectional printing
Highest resolution 1440 x 720 dpi
Paper feed method Friction feed
Interface Universal Serial Bus Specifications Revision 2.0
Electrical Specifications
Rated voltage AC 100 to 120 V AC 220 to 240 V
Rated frequency range 50/60 Hz 50/60 Hz
Rated current 3.0 A 1.5 A
Power consumption Operating: Approximately 120 W
Sleep mode: Approximately 6 W
Power off: Less than 0.5 W
Operating: Approximately 120 W
Sleep mode: Approximately 6 W
Power off: Less than 0.5 W
Paper Feeder Specifications
Paper core size Roll paper feeder (3 inch core diameter): Outer diameter less than 170 mm/One can be loaded
Paper length 89 to 1,000 mm
Paper width 102 mm (4 inches), 127 mm (5 inches), 152 mm (6 inches), 203 mm (8 inches), 210 mm (A4)
Ink Specifications
Type Ink cartridges
Ink type Six color water-based dye
Use by date Three years after manufacture
Storage temperature In the packaging: -20 to 40 ˚C (within one month at 40 ˚C)
Installed in printer: -20 to 40 ˚C (within one month at 40 ˚C)
Transporting: -20 to 60 ˚C (within one month at 40 ˚C, 72 hours at 60 ˚C)
Capacity 200 ml
Cartridge dimensions 25 (W) x 200 (D) x 100 (H) mm
c
Important:
❏ The ink freezes if left at below -15 ˚C for a long time. If it does freeze, leave it at room temperature (25 ˚C) for at
least four hours until it has defrosted (without condensation).
❏ Do not disassemble the ink cartridges or refill the ink.
SL-D700 Operation Guide
Appendix
96