1-4 Paper Handling
❏ If you want to print on the reverse side of an Ink Jet Card with
Maximum selected as the Printable Area setting, flatten the
card or curl it slightly toward the opposite side before loading.
❏ If ink smears on your documents when printing on thick
media, set the adjust lever to the “+” position. To change the
setting, open the printer cover and position the lever as shown
in the illustration.
Note:
❏ Return the adjust lever to the “0” position before printing on
media of normal thickness. Leaving the lever in the “+” position
may cause gaps in the printed image.
❏ When the adjust lever is in the “+” position, make sure the High
Speed setting in the printer driver’s Advanced dialog box is off.
To turn this option off, you may also need to change the Print
Quality setting or align the print head using the Print Head
Alignment utility.
If you wish to print on the reverse side of an Ink Jet Card with
Maximum selected as the Printable Area setting, flatten the
cards or curl them slightly toward the opposite side before
loading. Set the adjust lever to the “+” position before
printing.
To Next Page
Loading...
