Using Roll Paper 2-5
The roll paper is now loaded. Next, set up the printer software
and try printing. For details on setting up the printer software,
refer to “Printing on Roll Paper” on page 2-5.
Printing on Roll Paper
Once you have prepared your roll paper and it is loaded in the
printer, you must make settings in the printer software in order
to print.
Printing area and margins in Roll Paper
You can apply various settings for printing area and margins on
roll paper with driver settings. There are two types of margin
settings: Even if 3-mm of both side of paper or No Margins is
selected, the top margin is automatically set to 20 mm.
Refer to the table below for the instructions.
3-mm of both side of paper
Select Roll Paper as the Paper Source in the printer
driver.
When printing is finished, press the
z
roll paper button
once to print a cutting guideline about 12mm from the
bottom of the print data.
To print the next print job, press the
z
roll paper button
to feed the paper back to the printing position, then
apply printing. In this case, the space between the two
blocks of print data will be 36mm.
To Next Page
Loading...
