Using Roll Paper 2-9
The Roll Paper Option settings are as follows:
5. Click the Main tab and select media that you use as the Media
Type setting.
6. Click OK to close the printer software. Print your document
and proceed to the next section, “Removing the Roll Paper
from the Printer” on page 2-13.
Banner Mode Select this mode when you want to print multi-page
data as continuous data on the roll paper, rather
than as individual pages. When this check box is
selected, the Save roll paper check box is enabled.
Cut Sheet Mode Select this mode when you want to print multi-page
data as individual pages, rather than as continuous
data. When this check box is selected, the Print
page frame check box is enabled.
Save roll paper Select this check box when you do not want any
paper to be fed after the data is printed. This
feature is only available when Banner Mode is
selected.
Print page frame Select this check box to print a line on the roll paper
between pages in a multi-page document to
indicate where the paper should be cut. This
feature is useful when it is unclear where the page
breaks should be or where the paper should be cut
after the last page has been printed. This feature
is only available when Cut Sheet Mode is selected.
To Next Page
Loading...
