2-8 Using Roll Paper
Note:
Do not select Sheet Feeder as the Paper Source setting in the
printer software. Doing so will cause unnecessary paper to be fed
after each print job. If you accidentally select Sheet Feeder, cut
the paper off at the back of the printer before it feeds into the sheet
feeder, then turn the printer power off and on again.
4. Make the Roll Paper Option settings at the bottom of the
dialog box.
Paper
Source
Roll Paper A 3-mm margin will be left along both
sides of the paper.
No Margins No left or right margins will be left. Select paper size from
the Paper size list.
Paper Size
Page Size
Select a predefined paper or page size from the list or
define a custom size.
If you select a predefined paper or page size, when the
data exceeds the selected size, it will be printed as
individual pages on the roll paper. A 36-mm margin will
be printed between each page of data in a print job when
you press the
z
roll paper button.
Define a custom size by selecting User Defined in the list.
This will open the User Defined Paper Size or User
Defined Page Size dialog box where you can specify the
length and width of your document. As long as your paper
or page size is large enough, the data will be printed as
one page. This will allow continuous printing of the data
without page breaks.
To Next Page
Loading...
