Epson Stylus Photo R320 - Page 42

EPSON Stylus Photo R320 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 42
 When removing "Housing, Middle", the grounding spring may
detach and drop from "Main Board Unit". If this occurs,
reattach it to its original position referring to the following
figure.
Figure 2-8. Reattaching the Ground Spring
 "Fixed spring, Core" should be attached with fixing the "Ferrit
Core" as shown below.
Figure 2-9. Reattaching the Fixed spring, Core
Grounding Spring
Ferrite Core
Fixed spring, Core
 Make sure that "Panel FFC" is securely set and it is not reaching
the upper edge of the rib of "Housing, Middle" as shown in the
figure.
Figure 2-10. Mounting "Panel FFC"
 Make sure that the connector cable of "Power Supply Board" is
securely set in the groove of "Housing, Lower".
Figure 2-11. Mounting the Connector Cable
 Make sure that "Panel FFC" is not stuck under "Housing,
Middle".
 Make sure to tighten up the screws on the back of "Housing,
Middle" in the order as shown in the figure.
Rib Keep some clearance here.
Connector Cable
Groove