Epson Stylus Photo R320 - Page 44

EPSON Stylus Photo R320 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 44
 Reinstalling "Porous Pad, Paper Guide, Front"/"Porous Pad,
Paper Guide, Front, Support"
 Fold perpendicularly left and right sides of "Porous Pad,
Paper Guide, Front, Support" at the marks and install it to
"Paper Guide, Front". Make sure that the slit engages with
the rib located on the side of "Paper Guide, Front" so that
they will fit securely.
 Glue the three bond 1401 at 6 points indicated in
Figure 2-13.
 Install "Porous Pad, Paper Guide, Front" in piles. Put it
under the rib, and check if it is securely fit. Adjust the
clearance between "Porous Pad, Paper Guide, Front" and
"Paper Guide, Front" approximately in 0.5 - 1.0mm.
 Reinstalling "Porous Pad, Paper Guide, Front, Support"
 Insert the foot-parts into the holes of "Paper Guide, Front".
Then, put them under the rib and check if it is securely fit.
C A U T I O N
 Do not damage "Porous Pad, Paper Guide, Front, Support".
 Do not apply too much adhesive. Do not contaminate "Porous
Pad, Paper Guide, Front, Support" with the adhesive.
 Install "Porous Pad, Paper Guide, Front" immediately after
applying the adhesive.
 Make sure that the 3 porous pads are fit securely.