EPSON Stylus Photo R320 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 49
Reattaching the Main Board Assy
Connector cable for "Star Wheels/CDR Sensor" should be
routed as shown below.
Figure 2-20. Routing connector cable
Screw in the order as indicated at Figure 2-17.
Connector Cable
A D J U S T M E N T
R E Q U I R E D
When having replaced "Main Board", implement the
adjustment in the following order. (Refer to Chapter 3
"ADJUSTMENT")
When possible to read data from the old board
1. EEPROM data copy
When impossible to read from the old board
1. Replace "Waste Ink Pads" with new one.
(To count the amount of the waste ink)
2. Market Setting
3. USB ID Input
4. Waste Ink Pad Counter
5. Head ID Input
6. First Dot Adjustment
7. PW Sensor Adjustment
8. Head Angular Adjustment
9. Bi-D Adjustment
10. Offset Input for CR Motor Calorific Limitation
To Next Page
Loading...
