Epson Stylus Photo R320 - Page 52

EPSON Stylus Photo R320 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 52
 When reassembling "ASF Assy."
 Make sure that "Extension Spring, 0.45" is hooked on
"Frame, ASF" and "Roller, Retard Assy.".
 Check if "Torsion Spring, 6.45" is correctly installed on
"Paper Back Lever" and "Frame, ASF".
Figure 2-23. Reinstalling "Torsion Spring, 6.45"
 Check if "Paper Back Lever" and "Roller, Retard Assy."
move smoothly.
 Do not touch the cork of "Hopper".
 Screw the "Support Plate, Frame, ASF" in the order as
indicated below.
Figure 2-24. Reinstalling "Support Plate, Frame, ASF"
Torsion Spring, 6.45
1
2
 Reinstalling "ASF Assy."
 Install "Compression Spring, 2.51" on "Hopper", then
check if "Hopper" moves smoothly.
 Screw in the order as shown in the figure.
 Make sure that there is no gap between "ASF Assy." and
"Frame, Main".
 Reattaching connector cable of PF Motor and PG Motor
 Tighten the screws in the order as shown in the figure.
A D J U S T M E N T
R E Q U I R E D
 When having replaced "ASF Assy.", apply G-46 grease to the
specified points in adequate dose. (Refer to Chapter 4
"MAINTENANCE")
 When having replaced or removed "ASF Assy.", implement the
adjustment in the following order. (Refer to Chapter 3
"ADJUSTMENT")
1. First Dot Adjustment