Epson Stylus Photo R320 - Page 54

EPSON Stylus Photo R320 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 54
 External View
Figure 2-26. Removing "Holder, Shaft Assy." (2)
 Removing "LD Roller"
1. Release the dowels (x2) which secure "Paper, Block". Then, remove "Paper,
Block".
2. Release the dowels (x2) which secure "Shaft, LD Roller". Then, remove
"Shaft, LD Roller" and "Clutch" together from "Holder, Shaft, LD Roller".
3. Remove "LD Roller" from "Shaft, LD Roller".
Paper, Block
Spur Gear, 36.8
Clutch
Extension Spring, 0.143
Shaft, LD Roller
Dowel
PE Sensor Board
Hook
Torsion Spring, 0.22
Lever Sensor, PE
Holder, Shaft, LD Roller
LD Roller
Dowel
Dowel
Dowel
C A U T I O N
Do not touch "LD Roller" with bare hands.
 Reinstalling "LD Roller"
 Make sure to match the direction ( Mark) indicated on
"Shaft, LD Roller" with the direction ( Mark) indicated
on the back side of "LD Roller".
Figure 2-27. Reinstalling "LD Roller"
mark on "Shaft, LD Roller"
mark on "LD Roller"