Epson Stylus Photo R320 - Page 61

EPSON Stylus Photo R320 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 61
 External View
Figure 2-36. Removing "Carriage Unit" (2)
8. Remove the E ring, "Holder, Scale Right" and "Cam, CR, Right" from the
right side of "CR Guide Shaft".
9. Remove the screw which secures "Bushing, Parallel Adjust, Right", Then,
remove "Bushing, Parallel Adjust, Right".
10. Remove "Fixed Spring, CR Shaft, Right" from the hook of "Frame, Main".
Remove "Fixed Spring, CR Shaft, Right" from "CR Guide Shaft".
11. Remove the "E Ring, Flat Washer" which secure the "Holder, Scale Left".
12. Remove the E ring, the flat washer and the spring washer from the left side of
"CR Guide Shaft". Then, remove "Holder, Scale, Left"
13. Release "Cable, Head" from the hooks (x8) of "Holder, Shaft Assy.".
14. Slide "CR Guide Shaft" to the right and pull it out from "Cam, CR, Left".
Then, remove "Carriage Unit" and "CR Guide Shaft" together.
15. Pull out "CR Guide Shaft" from "Carriage Unit".
Bushing,
Parallel
Adjust, Right
Holder, Scale, Right
C.B.S (P4) 3x6
(6-8kgf•cm)
Fixed Spring,
CR Shaft,
Right
Hook
E Ring
Cam, CR,
Right
Cable, Head
Holder, Shaft
Assy.
Hooks
Cam, CR, Left
CR Guide Shaft
CR Guide Shaft
Holder, Scale Left
E Ring
Flat Washer
E Ring
Flat Washer
Spring Washer
Hooks