Epson Stylus Photo R320 - Page 73

EPSON Stylus Photo R320 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 73
 External View
Figure 2-54. Removing "CDR Guide Assy." (3)
8. Remove "Compression Spring, 5.1" and "Lock, Stacker" from "CDR Guide,
Upper".
9. Release the connector cable of "Star Wheel/CDR Sensor" from the groove of
"CDR Guide, Upper".
Compression Spring, 5.1
Lock, Stacker
Star Wheel/CDR Sensor
Groove
Hooks
Shaft and Positioning Hole
 Reinstalling "Star Wheel/CDR Sensor"
 Match the Shaft (x2) of "CDR Guide, Upper" and the
positioning hole of "Star Wheel/CDR Sensor".
 Route the connector cable correctly of "Star Wheel/CDR
Sensor" referring to the figure.
 Reinstalling "CDR Guide, Lower"
 Screw in the order as shown in the figure.
 Reinstalling "CDR Guide, Upper"
 Make sure that the hooks (x2) of "Lock Stacker" are
properly secured by the tension of "Compression Spring,
5.1".
 Make sure that "CDR Guide, Upper" is securely secured
with the hooks (x7) of "CDR Guide, Lower" and there is no
gap between "CDR Guide, Upper" and "CDR Guide,
Lower".
 Reinstalling "CDR Guide Assy."
 Install "CDR Guide Assy." in the order of left edge, right
edge and middle.
 Match the slot (x6) of "CDR Guide Assy." and the ribs (x6)
of "Frame, Main".
 Check if "Link, CDR Left (Right)" is correctly installed.
 Check if the connector cable of "Star Wheel/CDR Sensor" is
not interrupting "Link, CDR Right".
 Check if "Frame, EJ Assy." works with "CDR Guide Assy."
and moves smoothly.
 Reinstalling "Support Plate, Frame, Main"
 Screw in the order as shown in the figure.