Stylus Pro 4000 Field Repair Guide 4/28/05
Printer Component, Software Item, LCD Display, Printer Button Page 10.
Clear Counters (Clears the usage/life counter information for the following devices/operations)
Init All: (Initializes all the following counters at once)
NVRAM, RTC: (YY/MM/DD/HH), Cutter, CR Motor, CR Total, PF Motor, Head, Cleaner, Total Pages,
MAINT TANK, SPONGE, ASF,FEED ROLLER, PG, CR UNIT MAINT, CL UNIT MAINT, HEAD MAINT,
CUT UNIT MAINT (Sponge = Boarderless Pads)
MAINT INFO: (Page 88 - 98 in the Service Manual)
Menu E: (E1 - E17), Menu R: (R1 - R9), Menu S: (S1 - S25), Menu A: (A1 - A32), Menu B: (B1 - B48),
Menu P: (P1 - P42), Menu M: (M1 - M26), Menu O: (O1 - O28), Menu F: (F1 - F28), Menu N: (N1 - N22)
INIT INFO (Resets MAINT INFO menu data)
INIT. MENU E:, INIT. MENU R:, INIT. MENU S:, INIT. MENU A:, INIT. MENU B:, INIT. MENU P:, INIT.
MENU M:, INIT. MENU O:, INIT. MENU F:, INIT. MENU N:
Maintenance Mode 3: Press and hold the Pause, Down, and Right buttons and turn on the Printer
Shipment:
ADJ.Variable: Exec (Prints out the current adjustment settings)
Clean Head: Exec (Evacuates the ink in the Ink Tubes)
Clean Counter: Exec (Resets counters?)
Default Panel: Exec (Resets the Control Panel Settings to factory default)
Parameter Backup Mode: (Allows Parameter backup without the Printer being online)
1. Enter Maintenance Mode 2
: Press and hold the Left, Down, and Up buttons and turn on the Printer
2. Lift both (2) Ink Levers
3. Remove the Maintenance Tank
4. Move the Paper Release Lever to the released position.
Firmware Download Mode:
Hold the 4 Arrow Buttons and Power on for F/W Download Mode
To Next Page
Loading...
