Stylus Pro 4000 Field Repair Guide 4/28/05
Print Head Slant Adjustment (PF) Printer Component, Software Item, LCD Display, Printer Button Page 174.
6. Using a lens, inspect the printed pattern.
7. Adjust, and reprint, until the pattern is correct.
8. Tighten the 5 Screws, and reprint the pattern to verify that the pattern is still correct.
9. Re-install the Carriage Cover.
The pattern should look like this.
If the gap is larger at the top, pull the Lever
down
The Lever employs detentes to lock
it in place. Flex the top portion of
the Lever in the direction of the
pivot point to release the detentes.
To Next Page
Loading...
