Epson Stylus Pro 4900 - Page 38

For A4
Slide out the third extension of the output tray,
raise the flap, and then push the section back in.
For A3
Pull out the third section of the output tray, and
then raise the flap.
For super A3 or larger
Slide out the second and third extensions of the
output tray, and then raise the flap. Make sure
that you align the marks on the second extension
of the output tray and the paper cassette.
Note:
The output tray can hold up to 50 ejected cut sheets.
However, when the number of sheets that can be
loaded in the paper cassette is less than 50, the
maximum number the output tray can hold is the
same as the number of sheets in the paper cassette.
Do not allow more than 50 cut sheets to stack up on
the output tray. Also, do not mix roll paper and cut
sheets on the output tray.
When the optional SpectroProofer is installed,
remove each sheet as it is printed regardless of the
size. If multiple sheets stack up on the output tray,
color measurement accuracy may decline.
Tip:
Except when installing the optional
SpectroProofer, check that the paper eject support is
lowered. If the paper eject support is raised, lower it
before printing.
L
Make sure the printer is on.
Epson Stylus Pro 4900/4910 User's Guide
Basic Operations
38