F Paper eject support
Support smooth ejection of the printed paper by raising the supports when printing on plain roll paper and when
the optional SpectroProofer is installed. U “Loading roll paper” on page 29
G Front manual feeder
Feed paper into this slot when printing on cut sheets that are 0.8 mm thick or thicker. U “Loading and Ejecting
Thick Paper” on page 40
H Cartridge cover (right)
Open when replacing ink cartridges or Maintenance Box 1.
U “Replacing Ink Cartridges” on page 120
U “Replacing Maintenance Box 1” on page 121
I Maintenance Box 1
Container for collecting waste ink.
J Ink cartridges
Install ink cartridges on the left and right for a total of 11 colors. Ink cartridge order U “Screen View” on
page 14
K Print head
Fires ink via high density nozzles while moving left and right to print.
Do not move the print head by hand.
L Control panel
U “Control panel” on page 13
M Alert lamp
Lit or flashing when an error or warning occurs in the printer.
On : An error occurred. Check the contents of the error on the control panel's screen.
Flashing : An ink or paper low warning occurred. You can specify for which consumable this warning
should occur. The factory setting is Off (no warning). U “Maintenance Mode List” on
page 160
Off : No error.
N Printer cover
Open when loading thick paper, cleaning the inside of the printer, or removing jammed paper. Normally closed
when using the printer.
O Rear manual feeder
Epson Stylus Pro 4900/4910 User's Guide
Introduction
9
To Next Page
Loading...
