Epson SureColor F6200 - Adjusting the Media Feed

Roll Paper Margin setting Margins
15mm Top margin: 1.22 inches (31 mm)
Bottom and side margins: 0.6 inch (15 mm)
Note: If you selected Normal and one of these options as the Select Paper Type setting, the top margin
is 0.2 inch (5 mm):
• Premium Glossy 250
• Premium Semigloss 250
• Premium Luster 260
• Premium Semimatte 260
Parent topic: Media Handling
Related references
Paper Menu Settings
Setup Menu Settings
Adjusting the Media Feed
If your printouts contain horizontal banding, uneven tint, or stripes, you need to adjust the feed of the
media. You do this by printing and examining a test pattern, and then selecting the feed adjustments you
need.
Adjust the feed using the same media type and print conditions you use for printing. You may need to
adjust the feed again if you load media of a different width, change the feeding tension, or adjust the
suction.
Before adjusting the feed, make sure you have correctly loaded the media you plan to print on and
selected all the options you plan to use for printing.
Note: You can also adjust the feed during printing without printing a test pattern.
1. On the product control panel, press the left or right arrow button to select the tab and press the
OK button.
The Paper menu appears.
2. Press the up or down arrow button to select Custom Paper Setting and press the OK button.
The Custom Paper Setting menu appears.
33