2. Press the up or down arrow button to adjust the feed depending on these banding results in your
printout:
• If black bands or dark stripes appear, press the up arrow button to increase the feed amount.
• If white bands or pale stripes appear, press the down arrow button to decrease the feed amount.
3. Check the results in your printout and do one of the following:
• If further adjustment is necessary, repeat the last step.
• If the print quality is good, press the OK button.
Parent topic: Adjusting the Media Feed
Cutting Media
When you finish printing, do one of the following to cut the media:
• If you turned on the Auto Cut setting on the product control panel, your product automatically cuts the
media after printing each page.
• If you did not turn on the Auto Cut setting, follow the instructions here to cut the media manually.
Note: The minimum length of paper that you can cut with the built-in cutter is 2.36 inches (60 mm). If
your printed image is smaller, the built-in cutter must leave a margin that you can trim using a
commercially available cutter after removing the media from the product.
35
To Next Page
Loading...
