Setting Options Description
Nozzle Check — Prints a nozzle check pattern that you
can visually inspect and then run head
cleaning if necessary.
Head Cleaning Execute (Light) Lets you clean all or selected nozzles,
based on the nozzle check pattern.
All Nozzles Execute (Medium)
Select the lightest cleaning level first. If
Selected Nozzles Execute (Heavy)
nozzles are still clogged, select a
heavier cleaning.
Head Alignment Manual(Uni-D) Select when print results are grainy or
out of focus:
Manual(Bi-D)
Manual(Uni-D): when printing in one
direction.
Manual(Bi-D): when printing in both
directions. If head alignment with this
setting does not correct the problem,
select Manual(Uni-D).
Cutter Maintenance Adjust Cut Position Adjusts the cutter position in
increments of 0.039 inch (1 mm), from
Replace Cutter
–0.12 to 0.12 inch (–3 to 3 mm).
Replace Cutter: positions the cutter for
replacement.
Head Maintenance Move Head Positions the print head for cleaning
using the head maintenance kit.
Waste Ink Counter — Lets you reset the waste ink counter if
you replace the waste ink bottle before
being prompted by a message on the
control panel.
Parent topic: Using the Control Panel Menus
Related tasks
Checking for Clogged Print Head Nozzles
Cleaning the Print Head
Aligning the Print Head
Replacing the Cutter
42
To Next Page
Loading...
