143
4. Press the down arrow button to select Head Cleaning and press the right arrow button.
5. Press the up or down arrow button to select one of the following:
• To check for clogs followed by an automatic cleaning, select Check and Clean Nozzle and press
the right arrow button. Press the down arrow button to select Yes and press the OK button to start.
• To select the specific nozzles for cleaning, select Select Nozzles and press the right arrow button.
Press the up or down arrow buttons to select the color(s) that need cleaning, and press the OK
button to start.
• To clean all nozzles, select All Nozzles and press the right arrow button.
6. Select one of the following as the cleaning strength level:
• For a first cleaning, select Normal.
• If nozzles are still clogged after three normal level cleanings, select Heavy.
7. Press the OK button to start the cleaning cycle.
When the cleaning cycle is finished, the power light stops flashing and a confirmation screen
appears.
Caution: Never turn off the product during a cleaning cycle or you may damage it.
8. Select Nozzle Check and press the right arrow button.
9. Press the OK button.
The nozzle pattern prints.
10. Check the printed pattern to see if there are gaps in the lines.
Note: Use at least a 10× eye loupe to examine the pattern for any missing or deflected dots or
segments.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
