241
• When lifting the product, make sure you lift with your hands at the correct locations; otherwise, the
printer may fall or you may be injured. See the link below or the Start Here sheet for details on lifting
the product.
• Use correct posture when lifting the product.
• Make sure to remove all packing materials from the product and installation area.
• When placing the product on a stand with casters, make sure the casters are secured before you
perform any work so that they do not move. If the stand moves while you are performing any work, it
could cause an injury.
• When moving the product, make sure it is turned off, the power cables are unplugged from the outlets,
and all connecting cables have been removed. Avoid steps and uneven surfaces. If cables are
damaged, an electric shock or fire could occur.
• Avoid locations that are subject to rapid changes in heat or humidity, shocks or vibrations, or dust.
• Do not place or store the product outdoors.
• Do not place the product near excessive heat sources or in direct sunlight.
• Leave enough room around the product for sufficient ventilation. Do not block or cover openings in the
cabinet or insert objects through the slots.
• Do not obstruct the vents on the product. If the vents are obstructed, the internal temperature could
rise and cause a fire.
• Do not cover the printer with a cloth or install it in a location with poor ventilation.
• Make sure you secure sufficient space for installation of the product. See the link below.
• Do not install or store the printer in an unstable location or a location subject to vibrations from other
equipment. The printer could fall or tip over and cause an injury.
• Do not install the printer in locations subject to oily smoke and dust, or in locations subject to humidity
or where it could easily get wet. An electric shock or fire could occur.
• Keep the product away from potential sources of electromagnetic interference, such as loudspeakers
or the base units of cordless telephones.
• When connecting the product to a computer or other device with a cable, ensure the correct
orientation of the connectors. Each connector has only one correct orientation. Inserting a connector
in the wrong orientation may damage both devices connected by the cable.
• Do not put your hands inside the product or touch the flat white cable or print head during printing.
• Do not touch any areas inside the printer except for those indicated in the product's documentation;
otherwise, you may be shocked or burned.
To Next Page
Loading...
