Epson T3 Series User Manual

2. Installation
74 Safety and Installation (T, VT / EPSON RC+ 7.0) Rev.15
2.8 Saving Default Status
The Manipulator is already setup with the purchased Manipulator (s) at shipment.
However, just in case, we recommend saving the default Controller status. A USB
memory is necessary to save the Controller status.
For the procedure of Controller status storage, refer to following manuals.
T series Manipulator manual
VT series Manipulator manual
Setup & Operation 8. Memory Port

Epson T3 Series Specifications

General

Payload	3 kg
Number of Axes	4
Programming Language	EPSON RC+
Type	SCARA
Reach	400 mm