Version 3.00 Feb. 2019
APPLICATION DEVELOPMENT GUIDE
POSPrinter (TM-H5000II/TM-U590)
20
3.12 Automatic Recovery Function
The TM-H5000II/TM-U590
models feature a function for automatic recovery when
the power is turned on again after an interruption of power. Recovery processing
is performed automatically when the printer’s power is turned on again after an
interruption. The recovery processing restores the printer to the condition it was in
before the power was turned off.
3.13 Output without Flow Control on the USB/Ethernet Interfaces
The TM-H5000II/TM-U590 support outputting without flow control on the
USB/Ethernet interfaces. The operations differ by the firmware versions. See the
corresponding part of the section 2 of this manual.
3.14 LED Blinking w
hen BeginInsertion is executed
In
the case of the TM-H5000II TM-U590 models, settings can be made in the
SetupPOS utility so that the LED
of the Slip starts blinking when BeginInsertion is
executed. When the settings have been made in the SetupPOS utility, the LED of
the slip will start blinking to indicate that the device is waiting for the paper to be
inserted when the BeginInsertion method is executed.
To Next Page
Loading...
Need help?
General