Epson TM-H5000II series

Version 3.00 Feb. 2019
APPLICATION DEVELOPMENT GUIDE
POSPrinter (TM-H5000II/TM-U590)
8
2.4 Device Settings
The following explanation is about the settings for TM-H5000II/TM-U590.
2.4.1 Usable Device Specific Settings
For the TM-H5000II/TM-U590, the following device specific settings are settable
by the SetupPOS utility.
For the detail, please refer to the corresponding part of
the Section 2 of “EPSON OPOS ADK MANUAL APPLICATION DEVELOPMENT
GUIDE POSPrinter (TM Series)”
Tab Settings
Disable panel buttons
Assume print complete when data output finishes
Ignore firmware version check
Homogenize Error Codes
*1
General
Output complete timeout
Removal feed length [line]
Reverse feed removal
Slip
Blink LED with BeginInsertion
Bitmap TMFlogo...
*2
Method
Brightness
Color Bitmap
Primary
ERROR
OFFLINE
Log file name (full path name)
Status Log
Maximum file size [KB]
Default Value
*3
Multilingual font
*1
The operations differ by the firmware versions. See the corresponding part of
the section 2 of this manual.
*2
Settable only for the TM-H5000II.
*3
Available only for the Multilingual character model.