Epson TM-L100

57
Chapter 2 Setup
Setup using a Smart Device connected using SimpleAP
Prepare the following items.
• Smart device: iOS 12 or later/Android 8 or later
• Setup utility: Epson TM Utility
1
Connect the wireless LAN unit to the printer.
2
Turn on the smart device.
3
Start the printer in the SimpleAP mode.
The printer prints SSID and QR code.
"SimpleAP mode" on page 52
4
Start Epson TM Utility.
5
Run [Wi-Fi Setup Wizard].
6
Following the on-screen instructions, scan the printed QR code and connect the
printer with SimpleAP.
7
Configure the network settings following the on-screen instructions.
8
When the settings are complete, exit Epson TM Utility.
9
Turn off the printer.
Wireless network settings of the printer is completed.