41
Chapter 2 Setup
Installing the Printer
You can select whether to eject printed paper from the top side or from the front side.
The paper ejection direction can be changed by switching the attachment position of the printer covers.
The printer is shipped with the covers attached so that paper is ejected upward (from the top side). When you
want to eject printed paper frontward (from the front side), see the following pages to switch the attachment
position of the covers.
• Removal procedure: "When Ejecting Paper Upward" on page 103
• A
ttachment procedure: "For Ejecting Paper Frontward" on page 106
Ejecting Paper Upward Ejecting Paper Frontward
• Place the printer on a flat surface.
• Take measures to prevent the printer from moving due to vibrations when using the cash drawer.
• Do not place the printer in locations subject to high dust levels.
• Do not give a high impact on the printer during operation. Doing so may cause the print failure.
• Be careful not to place cords or foreign substances under the printer.
• You can install the printer as a wall hanging printer if you use the optional Wall Hanging Bracket
Set (OT-WH30). Refer to the installation manual of the Wall Hanging Bracket Set for details.
• When you have set the printer to eject printed paper from the front side, you can flip printed
pages upside down by enabling the "Batch rotate print (Upside Down)" function. For more
details, see "Software Settings" on page 65.
To Next Page
Loading...
Need help?
General
