81
Chapter 3 Advanced Usage
Software Setting Mode
Set the printer's memory switches and customized values.
See "Software Settings" on page 65 for information about available functions and settings and how to set them.
F
ollow the steps below.
1
After running a self test, hold down the Feed button for at least one second to enter
the Mode selection.
The Mode selection guidance is printed, and the Paper LED flashes.
2
Briefly press the Feed button three times (less than one second), and then hold it
down for at least one second to enter the Software settings mode (Customized value
setting).
The Software setting mode guidance is printed, and the Paper LED flashes.
You can also make the software settings using the ESC/POS commands.
To Next Page
Loading...
