83
Chapter 3 Advanced Usage
2
Briefly press the Feed button four times (less than one second), and then hold it
down for at least one second to enter the Restore Default Values.
The guidance is printed.
3
Briefly press the Feed button once (less than one second), hold it down for at least
one second. (Hold down the Feed button until the message of restore completion is
printed.)
Interface Setup Mode
Use this mode to setup the interface and other settings.
Follow the steps below.
1
After running a self test, hold down the Feed button for at least one second to enter
the Mode selection.
The Mode selection guidance is printed, and the Paper LED flashes.
2
Briefly press the Feed button five times (less than one second), and then hold it down
for at least one second to enter the Interface Setup mode.
The guidance is printed.
3
After briefly pressing the Feed button (less than one second) for the number of times
shown in the print result, hold down the button for more than one second to select
the setting items.
Initialize
Select [Wi-Fi & Ethernet Setup] or [Bluetooth Setup] and select [Initialize] to restore the communication
settings to the factory default. The printer is reset and restarted.
SimpleAP mode (Wi-Fi + Bluetooth model)
Select [Wi-Fi & Ethernet Setup] and select [SimpleAP] to start in SimpleAP mode. The printer is reset and
restarted, and it begins printing the "SimpleAP Start" information.
Select this to quickly set up a network connection.
Auto re-connect to iOS device (Wi-Fi + Bluetooth model)
In Wi-Fi + Bluetooth model, select [Bluetooth Setup] and then select [Auto Re-Connect iOS], you can select
whether to enable or disable auto reconnection to iOS devices.
For information on the Quick connection function, see "Simple Setup for Wireless LAN" on page 28.
• For details on the auto re-connect function, see "Auto Reconnect Feature" on page 134.
• Y
ou can change the settings with TM-m30III Utility and Epson TM Utility.
To Next Page
Loading...
Need help?
General
