90
Chapter 3 Advanced Usage
Resetting the Interface Settings
Follow the steps below to restore the network settings to the factory default.
1
Turn off the printer and close the roll paper cover.
2
If the bottom cover is attached, remove the cover.
See "Removing the Printer Covers" on page 103 for details on removing the bottom cover.
3
Hold down the status sheet button while turning on the printer.
A message is printed indicating that resetting is being performed, and the printer restarts.
The interface settings can also be initialized from the Interface Setup Mode. See "Interface Setup
Mode" on page 83 for more details.
To Next Page
Loading...
