EasyManuals Logo

Epson TM-m30III User Manual

Epson TM-m30III
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #84 background imageLoading...
Page #84 background image
84
Chapter 3 Advanced Usage
Bluetooth Security Settings (Wi-Fi + Bluetooth model)
For Wi-Fi + Bluetooth models, select [Bluetooth Setup], and then select [Security], and you can change the
Bluetooth security settings.
Pairing method when the security is set to Middle/High (from the printer)
When the security is set to Middle/High and the printer is ready to be paired, perform the following procedure.
1
Load paper in the printer, and then turn it on.
2
Open the roll paper cover, hold down the FEED button (two seconds), and then close
the roll paper cover.
A guidance that starts with "Next Action" will be printed.
3
Briefly press the Feed button (less than one second), and then hold down the button
for at least one second.
4
A status sheet is printed, and the Bluetooth LED flashes a pattern indicating that pair-
ing is now possible.
After this, the printer will be able to be paired for one minute only.
If you change the security settings, the link key (pairing information) will be deleted. If the printer
is already paired with a terminal, unpair them and then pair again.
When the security level is set to "Low", pairing is always possible, which increases the possibility of
unauthorized use by a third party. Change the setting at your own discretion and responsibility
with full understanding of the risk.
You can change the settings with TM-m30III Utility and Epson TM Utility.
Security Pairing Mode Pairing Method
Low Pairing is always possible Just Works
Middle
(initial setting)
Pairing is possible for one minute after printing the status sheet Just Works
High Pairing is possible for one minute after printing the status sheet Numeric Comparison/Passkey Entry
Make sure no errors have occurred and that the printer is not off-line.
You cannot pair the printer while the network is starting up immediately after the power is
turned on.
You can enable pairing also by printing the status sheet by pressing the status sheet button.

Table of Contents

Other manuals for Epson TM-m30III

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson TM-m30III and is the answer not in the manual?

Epson TM-m30III Specifications

General IconGeneral
TypePOS printer
Print technologyThermal
Maximum resolution203 x 203 DPI
USB portYes
Serial interface-
Connectivity technologyWired & Wireless
Ethernet LANNo
Internal memory- MB
Product colorWhite
Mobile operating systems supportedAndroid, iOS

Related product manuals