Epson TM-T20II

Chapter 2 Setup
49
2
Character code table default
Selectable from 43 pages including user defined page
Initial setting: Page 0 (PC437: USA, Standard Europe)
International character default
Selectable from 18 sets
Initial setting: USA
Interface selection (only for serial + USB model, and ethernet + USB
model)
The tables below describe the modes you can set for the printer to control the dual interfaces.
Automatic selection:
The interface for UIB (Universal Interface Board) or Built-in USB to which data is transmitted
first is selected.
When using the Ethernet + USB model, however, the built-in USB is not available for Automatic
selec
tion mode. Select "Fixed to built-in USB" to use the USB interface.
The selected interface is enabled until the power is turned off or the printer is reset.
For serial + USB interface models
For ethernet + USB interface models
For the character code table, see "Character Code Tables" on page 96.
For the character code table, see "International Character Sets" on page 140.
Interface mode Serial Built-in USB
Automatic selection (initial setting)
Available Available
Fixed to serial
Available Not available
Fixed to built-in USB
Not available Available
Interface mode Ethernet Built-in USB
Automatic selection (initial setting)
Available Not available
Fixed to ethernet
Available Not available
Fixed to built-in USB
Not available Available