Appendix
95
13: Interface
Settings
1: Receive Buffer Capacity 4KB, 45 bytes
2: BUSY Condition Rece
ive Buffer Full or Offline, Receive
Buffer Full
3: Auto Line Feed Always disabled, Always enabled
4: State to cancel buffer BUSY Not BUSY = 25
6 bytes, Not BUSY = 138
bytes
5: Output Paper-end Signals Paper End Sensor Ena
bled, Disabled
6: Error Signal Ena
bled, Disabled
15: Logo Emulation Of
f, 180 Dpi Logo Mode
16: Automatic
Paper
Reduction
1: Upper Margin Enable, Disa
ble
2: Lower Margin Enable, Disable
3: Blank Line Spacing 25%, 50%, 75%, Not Reduce
4: Blank Space 25%, 50%, 75%, Not Reduce
5: Barcode Height 25%, 50%, 75%, Not Reduce
17: Interface Selection UIB, Built-in USB, Auto
18: Power Supply Unit Capacity Level 1(Low) to Level 3(High)
Setting Items
Selection of software settings
The initial setting is underlined.
1st page 2nd page 3rd page
To Next Page
Loading...
