Epson TM-T88

Rev. A Command Descriptions 1-35
TM-T88/T88P (TM-T85/T85P) Information Manual
* For TM-T88/T88P, when the cover is open, paper detection may be incorrect.
Drawer kick-out connector status (n=2, 50).
DLE EOT n
[Name] Real-time status transmission
[Format] ASCII DLE EOT n
Hex 10 04 n
Decimal 16 4 n
[Range] 1 ≤ n ≤ 4
DLE EOT n transmits the specified status in real time.
With a serial interface model, this command is executed even when the printer is off-line, the receive
buffer is full, or an error occurs.
With a parallel interface model, this command is not executed in the following status because the
printer is busy and unable to receive data from the host computer.
❏ Receive buffer is full when DIP switch 2-1 is set to On.
❏ Printer is off-line, an error occurs, or receive buffer is full when DIP switch 2-1 is set to Off.
*2, 3
Off 00 0 Paper roll end sensor: paper present.
On (0C) (12) Paper roll end sensor: paper not present.
4 Off 00 0 Not used. Fixed to Off.
5, 6 — — — Undefined.
7 Off 00 0 Not used. Fixed to Off.
Bit Off/On Hex Decimal Status
0
Off 00 0 Drawer kick-out connector pin 3 is LOW.
On 01 1 Drawer kick-out connector pin 3 is HIGH.
1-3 — — — Undefined.
4 Off 00 0 Not used. Fixed to Off.
5, 6 — — — Undefined.
7 Off 00 0 Not used. Fixed to Off.
Bit Off/On Hex Decimal Status