Rev. A Command Descriptions 1-39
TM-T88/T88P (TM-T85/T85P) Information Manual
Paper sensor status
Bar Code Commands
The TM-T88/T88P (TM-T85/T85P) supports the following bar code commands:
Command Name
GS h Set bar code height
GS w Set bar code width
GS k Print bar code
GS H Select printing position of Human Readable Interpretation (HRI) characters
GS f Select font for HRI characters
GS h n
[Name] Set bar code height
[Format] ASCI GS h n
Hex 1D 68 n
Decimal 29 104 n
[Range] 1 ≤ n ≤ 255
GS h n selects the height of a bar code. n specifies the number of dots in the vertical direction. One
dot corresponds to 1/180 inch. The default setting is n=162.
Program Example
PRINT #1, CHR$(&H1B);"v";
Bit Off/On Hex Decimal Status
0, 1
Off 00 0 Paper roll near-end sensor: paper adequate.
On 03 3 Paper roll near-end sensor: paper near end.
2, 3
Off 00 0 Paper roll end sensor: paper present.
On (0C) (12) Paper roll end sensor: paper not present.
4 Off 00 0 Not used. Fixed to Off.
5, 6 — — — Undefined.
7 Off 00 0 Not used. Fixed to Off.
To Next Page
Loading...
