16
Restriction
❏ If power is restored the device or the cover is open during printing, printing may not occur properly.
❏ To turn the device power off and on, be sure to allow an interval of five seconds or more between power
off and on.
❏ Use a switching hub to connect the device.
If no switching hubs are used, the device in online status is more likely to be judged as offline depending
on the traffic condition.
❏ Drawer open operates when the TM intelligent printer is in online status (when the roll paper is loaded
and the roll paper cover is closed).
If you are using a TM-i (firmware version 3.0 or later)/ TM-DT (firmware version 2.2 or later), if you designate
forced transmission mode with ePOS-Print XML, it will operate offline.
❏ When the specified timeout time has passed after printing starts, the printing is canceled, but the data
recognized by the printer before print cancelling process starts is printed.
To Next Page
Loading...
Need help?
General