31
Chapter 2 Sample Program
2
TM-DT Settings
Configure the following settings to TM-DT.
❏ Initial OS Settings (p. 31)
❏ Initializing the ePOS-Device (p. 32)
❏ IP Address Settings (p. 33)
❏ Service Startup Settings (p. 34)
❏ Server Direct Print Settings (p. 35)
❏ Registration of TM Printer (p. 37)
Initial OS Settings
This section describes the procedure for making OS settings when the TM-DT is turned on for the first time.
1
Make sure the power to the TM-DT is off, and then connect the display and
keyboard.
2
When the power to the TM-DT is turned on for the first time, the Windows
Embedded POS Ready 2009 Setup screen is displayed briefly.
3
The logon screen is displayed. Enter your user name and password.
Refer to the TM-DT Technical Reference Guide for details about initial settings.
4
The desktop for the OS is displayed. Select [Start] - [Control Panel] - [Clock,
Language, and Region] - [Date and Time]. Set the date, time, and time zone.
• A display and keyboard are required to set up the OS.
• Connect the display when the power to the TM-DT is off.
Connecting the display when the power is on could cause the display to not function
correctly.
This section describes details for Windows Embedded POS Ready 2009. If you are using a
different OS, substitute the name of the OS as appropriate.
To Next Page
Loading...
