146
Enter the folder path name for the Location setting in one of the following formats depending on
the Communication Mode setting you selected:
• SMB: \\host_name\folder
• FTP: ftp://host_name/folder_name
• For a network folder or FTP location with a password, select the User Name field and use the
displayed keyboard to enter the user name. Then select the Password field and enter the
password.
• For an FTP location, enter the FTP server port number in the Port Number field. If there is a
firewall between the product and FTP server, select the Connection Mode field and select
Passive Mode.
9. Select OK.
Note: If you need to edit or delete scanning contacts, the procedures are the same as for fax contacts.
Parent topic: Setting Up and Scanning to a Network Folder or FTP Server
Related tasks
Scanning to a Network Folder or FTP Server
Entering Characters on the LCD Screen
Related topics
Setting Up Contacts Using the Product Control Panel
Registering Contacts for Network Folder or FTP Scanning - Web Config
You can register a list of contacts for scanning to a network folder or FTP server using Web Config and
your computer's internet browser.
Before you begin, print a network status sheet and locate the IP address for your product on the sheet.
Note: These instructions use Internet Explorer as an example browser.
1. Start Internet Explorer on a computer that is using the same network as your product.
2. Type your product's IP address into the address bar and press Enter.
3. Click Continue to this website (not recommended).
4. Click Contacts.
5. Select the number you want to use for the contact you are adding and click Edit.
To Next Page
Loading...
Need help?
General
