Epson WF-7525 - Page 66

To Next Page

To Previous Page

Epson WF-7520/7510/7010 series Revision A

Disassembly/Reassembly Routing FFCs/cables 66

Scanner Motor Assy

 When routing Scanner Motor cable and scanner grounding wire, follow

the procedure below.

1. Route the scanner grounding wire through the hooks and ribs, and

insert it into the hole of the Scanner Housing Lower.

2. Install the Scanner Motor Assy.

(p 62)

3. Route the Scanner Motor cable through the hooks and ribs, and insert

it into the hole of the Scanner Housing Lower.

 After inserting the Scanner Motor cable and scanner grounding wire into

the hole of the Scanner Housing Lower, confirm the Scanner Motor cable

is over the scanner grounding wire.

Scanner

Motor

cable

Route

inside rib.

Scanner

Motor

Assy

After Scanner Motor Assy is installed

Hole of Scanner

Housing Lower

Hook

Rib

Hook

Rib

Before Scanner Motor Assy is installed

Scanner grounding wire

Hole of Scanner

Housing Lower

Route

inside rib.

Bottom of the Scanner Unit

When routing the cables/FFCs on the bottom of the Scanner Unit, follow the

procedure below.

1. Pull the Scanner FFC out from the hole A of the Scanner Housing Lower,

and secure it on the position shown above with double-sided tape.

2. Pull the Scanner Motor cable and scanner grounding wire out from the

hole B of the Scanner Housing Lower.

3. Insert the Scanner FFC into the hole 1 of the Scanner FFC Cover, and

insert the Scanner Motor cable and scanner grounding wire into the hole 2

of the Scanner FFC.

4. Install the Scanner FFC Cover to the Scanner Housing Lower.

(p 62)

Scanner Motor cable

Hole A

Hole B

Double-

sided tape

Before Scanner FFC Cover is installed

Scanner FFC Cover

Hole 1

Hole 2

Scanner grounding wire

Bottom of Scanner Unit

Scanner FFC Cover

Scanner FFC

When routing the Scanner FFC, follow the procedure below.

1. Fold the Scanner FFC along the fold lines and route the FFC through the rib A and along the standard line so as not to let the FFC touch the wall of the

Scanner Housing Lower, and then insert the FFC into the hole of the Scanner Housing Lower.

2. Secure the Scanner FFC on the position shown above on the Scanner Housing Lower with double-sided tape (x4).

3. Connect the Scanner FFC to the connector on the CIS Module, and secure the Scanner FFC on the position shown above on the CIS Module with double-

sided tape.

4. Install the CIS Module to the Scanner Carriage.

5. Route the Scanner FFC under the rib B (x2) of the Scanner Carriage, and confirm the FFC does not come over the guide ribs (x2) of the Scanner Carriage.

Step 1, 2

Hole of Scanner

Housing Lower

Rib A

Double-sided tape

Wall of Scanner

Housing Lower

Scanner

FFC

Standard line

Connector

CIS Module