Epson XP-4200 Series - Page 132

Error Messages Solutions
You need to replace Ink Cartridge. To ensure you receive premium print quality and to help protect your
print head, a variable ink safety reserve remains in the cartridge when
your printer indicates it is time to replace the cartridge. Replace the
cartridge when you are prompted to do so.
“Ink Cartridge Codes” on page 154
The printer's borderless printing ink pad is
nearing the end of its service life. It is not a user-
replaceable part. Please contact Epson support.
Contact Epson or an authorised Epson service provider to replace the
borderless printing ink pad*. It is not a user-serviceable part. The
message will be displayed until the ink pad is replaced.
Select Dismiss to resume printing.
The printer's borderless printing ink pad has
reached the end of its service life. It is not a user-
replaceable part. Please contact Epson support.
Contact Epson or an authorised Epson service provider to replace the
borderless printing ink pad*. It is not a user-serviceable part.
Borderless printing is not available, but printing with a border is
available.
Paper Setup Auto Display is set to O. Some
features may not be available. For details, see
your documentation.
If Paper Setup Auto Display is disabled, you cannot use AirPrint.
System Error
An error occurred. Turn the device o and back
on again. If this occurs again, contact Epson
support.
Try the following solutions.
1. Turn the printer o and on again.
2. If you are using a Wi-Fi connection, turn the wireless router
o
and on
again.
If the error message is still displayed, make a note of the error code, and
then contact Epson support.
The combination of the IP address and the
subnet mask is invalid. See your documentation
for more details.
Enter the correct IP address or default gateway. Contact the person who
setup the network for assistance.
To use cloud services, update the root certicate
from the Epson Web Cong utility.
Run Web Cong, and then update the root certicate.
Check that the printer driver is installed on the
computer and that the port settings for the
printer are correct.
Click Print Queue on the printer driver's Maintenance tab. Make sure
the printer port is selected correctly in Property > Port from the Printer
menu as follows.
Select "USBXXX" for a USB connection, or "EpsonNet Print Port" for a
network connection.
Check that the printer driver is installed on the
computer and that the USB port settings for the
printer are correct.
Recovery Mode The printer has started in recovery mode because the rmware update
failed. Follow the steps below to try to update the rmware again.
1. Connect the computer and the printer with a USB cable. (During
recovery mode, you cannot update the rmware over a network
connection.)
2. Visit your local Epson website for further instructions.
*
In some print cycles a very small amount of surplus ink may be collected in the ink pad. To prevent ink leakage
from the pad, the product is designed to stop printing when the pad has reached its limit. Whether and how
oen
this is required will vary according to the number of pages you print using the borderless print option. e need
for replacement of the pad does not mean that your printer has ceased to operate in accordance with its
specications. e printer will advise you when the pad requires replacing and this can only be performed by an
authorised Epson Service provider. e Epson warranty does not cover the cost of this replacement.
Solving Problems > A Message is Displayed on the LCD Screen
132