Epson XP-4200 Series - Page 87

Note:
If you cannot nd the button or you are setting up using the soware, see the documentation provided with the wireless
router.
1.
Select
on the home screen.
To select an item, use the
u d l r buttons, and then press the OK button.
2.
Select Wi-Fi (Recommended).
3.
Press the OK button.
If the network connection is already set up, the connection details are displayed. Select Change Settings to
change the settings.
4.
Select Push Button Setup (WPS).
5.
Follow the on-screen instructions.
If you want to check the network connection status for the printer aer setup is complete, see the related
information link below for details.
Note:
If connection fails, restart the wireless router, move it closer to the printer, and try again. If it still does not work, print a
network connection report and check the solution.
Related Information
& “Checking the Printer's Network Connection Status (Network Connection Report)” on page 88
Making Wi-Fi Settings by PIN Code Setup (WPS)
You can automatically connect to a wireless router by using a PIN code. You can use this method to set up if a
wireless router is capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a PIN code into the wireless
router.
In These Situations > Re-Setting the Network Connection > Making Wi-Fi Settings from the Control Panel
87