Erbauer ERB238MSW - Installing the Dust Bag; Installing the Hold-Down Clamp

ERBAUER 254MM (10”) SINGLE BEVEL SLIDING MITRE SAW
4. Installing the dust bag

dust bag (1).
2) Place the dust bag neck opening around the


5. Installing the hold-down clamp
1) Loosen the lock knob (1) from the rear side

2) Place the hold-down clamp assembly (3) in


Warning: When using stop block on
the right side, hold-down clamp must
also be in right side. Using hold-down clamp
on the left side during this operation can cause

Fig 6
1
3
2

4 4
Fig 7
3
2
1